Here is a pattern plane design I hope you enjoy. The motor is setup as a contra drive with a governor (a running idle). On the rf9 controller switch C is for stall turns and spins (I do normal flying on high rate aileron with big expo so snaps do not require a switch. Low rate aileron will induce high rate rudder and elevator which I needed to program in for spins and stall turns - this gives unrealistic rudder power). Switch D on the RF9 controller is setup for a fine, dark, lasting stream of smoke which I use to evaluate tracking during a maneuver. I find the use of the skygrid helpful, as well as using autozoom and 0% Camera Lag (setting/Camera). The battery will die after about 12 minutes of flying. This file should work on RF8 and 7.5 but switch assignments may be different.

Many thanks to Donamy for his efforts to get my solid works model into a working RF model. Without him this wouldn't be possible. Thank you again Sir!