Steinbach (Sbach) 342 D-EIXA as it appeared at the Swiss Aerobatics Championship in 2009. Resource photos for the actual plane can be seen in this gallery:
http://www.andrebernet.ch/gallery/v/aviation/0909_SNAC/D-EIXA/?g2_page=2
This CS includes a modified and matched Specular map, a modified Normal map that adds the canopy hatch line, adds the horizontal cowl line, adds the two venturi ducts near the canopy, and re-locates the cowl screws.
The paint layer was meticulously kept clean and lined up, with all lines running into and through the control surface gaps. The inside of the cowl was changed to a carbon fiber weave.
There are a few small holes at the intersection of the vertical stab and the rear spine of the fuse. This slight visual imperfection is in the 3D mesh of the original model, and therefore cannot be covered up by the CS.
This is a high-rez 4096 x 4096 CS and performs best on a high-end graphics card with Normal maps set 'ON'
Original 3D model by pccdtk and inky00
CS by twoeleven
Enjoy!
Griff
twoeleven
http://www.andrebernet.ch/gallery/v/aviation/0909_SNAC/D-EIXA/?g2_page=2
This CS includes a modified and matched Specular map, a modified Normal map that adds the canopy hatch line, adds the horizontal cowl line, adds the two venturi ducts near the canopy, and re-locates the cowl screws.
The paint layer was meticulously kept clean and lined up, with all lines running into and through the control surface gaps. The inside of the cowl was changed to a carbon fiber weave.
There are a few small holes at the intersection of the vertical stab and the rear spine of the fuse. This slight visual imperfection is in the 3D mesh of the original model, and therefore cannot be covered up by the CS.
This is a high-rez 4096 x 4096 CS and performs best on a high-end graphics card with Normal maps set 'ON'
Original 3D model by pccdtk and inky00
CS by twoeleven
Enjoy!
Griff
twoeleven
