Lighthorse01
Member
Any way to have two separate Bungee Anchor's on a map. I have two short pull at two different locations, but it always uses one.
Bungee Anchor
- Thread starter Lighthorse01
- Start date
legoman
Well-known member
I have not tested it. but I think it works this way based on other similar fuctions.
When at a specific pilot spawn rf will automaticly grab the closest bungee spwan. try moving the bungee spawn that is being used by both away from the pilot spawn that is using the wrong bungee or move the pilot spawn slightly closer the bungee you want it to use.
When at a specific pilot spawn rf will automaticly grab the closest bungee spwan. try moving the bungee spawn that is being used by both away from the pilot spawn that is using the wrong bungee or move the pilot spawn slightly closer the bungee you want it to use.
Lighthorse01
Member
One is at the airport and the other is at the cliffs probably 100 miles away. Its on Sierra Nevada map. Kind of strange watching it just fly away, until you pull up hard
Lighthorse01
Member
Yes one is set to 600 the other is set to 1200