I am trying to add the Spektrum SAFE controller to a modified Electristar. I modified the vehicle physics in RF as best I could to simulate an electric powered Sig LT-40. I've looked at a few existing SAFE enabled models that came with RF and also downloaded a couple from the swap pages to see how others have done it. I've added the controller, made the connections between the simulator controller, the Spektrum SAFE controller and the servos. In flight, the controller seems to be active regardless of channel 8 (switch B in my case) position. The controller however seems to only limit roll and pitch to about 90 degrees and does not return to level flight. In other words, I can't loop or barrel roll, but if I go hands-off, the plane just very slowly returns to level flight assuming sufficient altitude, just like any good trainer aircraft should. I also added the SAFE controller to the stock Electricstar with the same results. Any and all help appreciated.