Real flight sim

T

timbo2023

New member
Hi all just wondering about the controller
That comes with the sim pack if the controller can change or be changed from mode 2 to mode1 with throttle and aileron on right stick and rudder and elevator on left stick thanks heaps
 
If you're talking about the current model, the InterLink DX which is available with RealFlight Evolution, then it's quite easy to do. If you happen to be talking about an older InterLink type that was bundled with an older version of RealFlight, then technically the answer is still yes, but it would require opening and rewiring your controller.

Assuming the DX, there are three steps:
  1. Switch the controller device's behavior. This is a hardware change to the self-centering (springy) behavior of the two gimbals.
    1. Locate the slider on the back of the InterLink DX, covered by a hinged plastic cover.
    2. Open the plastic cover.
    3. Center both sticks as perfectly as you can. This helps with the next step.
    4. Move that slider from the Mode 2/4 position to the Mode 1/3 position. (It takes a little bit of force.)
  2. Select the "Mode 1" radio profile in the sim. This causes RF to interpret the signals from each stick the way you desire (throttle on the right, elevator on the left).
    1. From the main menu, select Settings -> Controller -> Configure Controller.
    2. Expand the radio profile dropdown and select "InterLink DX (Mode 1)".
    3. Click OK.
  3. Change the Radio gadget mode. This causes the sticks displayed in the Radio gadget to match the above two changes.
    1. From the main menu, select Settings -> User Interface -> Gadgets -> Radio -> Radio Gadget Mode.
    2. Choose "Mode 1".
    3. Click Select and close the menu.
 
You must log in or register to reply here.
Back
Top