A few years back I purchased RF7.5 complete with the Transmitter Interface. I was running it on my works Dell laptop with Windows 8 using my Spektrum DX6i with no issues at all.
Long story short due to changes at work I have not had the ability to use the software for a few years now.
Over Christmas I brought a new laptop running Windows 11 and have just tried to install the software on it. The software installed ok, but when I tried to run it, the software kept asking me to connect the controller. The controller was pugged into the machine via the transmitter interface and turned on as I used to use it, but the software won't recognise, or see, the transmitter.
I can't enter the serial numbers and can't get it to work either. Any suggestions would be very much appreciated.
The realflight version is 7.50.015
The laptop is HP Omnibook 7 as below
Thanks.
Long story short due to changes at work I have not had the ability to use the software for a few years now.
Over Christmas I brought a new laptop running Windows 11 and have just tried to install the software on it. The software installed ok, but when I tried to run it, the software kept asking me to connect the controller. The controller was pugged into the machine via the transmitter interface and turned on as I used to use it, but the software won't recognise, or see, the transmitter.
I can't enter the serial numbers and can't get it to work either. Any suggestions would be very much appreciated.
The realflight version is 7.50.015
The laptop is HP Omnibook 7 as below
Thanks.