[84320] Horizontal line pixels duplicated when both legacy menu and title bar are enabled

[legoman]

I am not sure if this specific to my hardware geforce 970 and dell U2412M or resolution/aspect ratio 16x10 1920x1200

when BOTH the legacy menu and the show title bar are enabled some horizontal lines are duplicated and drawn again on the next line above instead of the correct next line

To recreate
load an airport with a long striaght edge with a hard color edge where you would notice the stairstep with antialiasing (waterpark works well)
enable both legacy menu and the show title bar
enter fly or hover mode and postion the camera to look at the edge
angle the camera so the "cliff" steps are visible see attached image
toggle the legacy menu and or titlebar and observe the changes.


note the cliffs (two pixel stair step) in the red circles and the line of pixels between the red arrows. there are more rows there are just less noticable as they are in similar colored areas with no hard edges



super zoomed in jpg. jpg compression is likely the reason for any variation

 

[Ryan Douglas]

Fascinating. I have filed case 84320 to address that. Hopefully we can reproduce it ourselves. Thank you for the report!

 

[legoman]

Fascinating. I have filed case 84320 to address that. Hopefully we can reproduce it ourselves. Thank you for the report!

on my screen they occur at regular intervals about 33-34 pixels a part so about 33-34 lines at my resolution and are really disrtacting once you notice them.

i found that running the sim at 25% speed and an aircraft that can hover unaided and letting it drift some helps. as you can focus at the background and not the aircraft.

it still occurs in 10.00.070.