I was excited to get the RF9, then the upgrade. my issue is that i'm trying to setup the flaps switch on switch B. when prompted to assign a switch nothing will accept. i'm trying to use the B 3 position toggle. the program won't accept it. only thing it accepts is the dial knob and it's proportional. contacting HH, proved useless. I was told I can't use any non-proportional switch. even using all available switches, it won't accept. i'm confused
I would “assume” that when given an option for proportional, toggle, or tri state, I should be able to
use them on my transmitter.
Also, I’d like to get a “reset” switch on the transmitter.
Same scenario, no response from the switches.
what am I doing wrong
I would “assume” that when given an option for proportional, toggle, or tri state, I should be able to
use them on my transmitter.
Also, I’d like to get a “reset” switch on the transmitter.
Same scenario, no response from the switches.
what am I doing wrong